Seat Backrest Cover - Second Row, 20 Percent

Seat Backrest Cover - Second Row, 20 Percent

Removal and Installation

NOTE: For parts identification and locations, refer to Seat - Exploded View, Second Row Seat - Exploded View, Second Row.

1. Remove the screw and pivot bolt cover.
- Route the attaching strap through the pivot bolt cover.

2. Release the 2 lower backrest cover J-clips.

3. Remove the pin-type retainer and detach the LH side attaching strap.

4. Remove the 2 screws and RH side shield.
- Raise the backrest upright to access and remove the center screw.

- Release the 2 pin-type retainers.

5. Remove the pin-type retainer and detach the RH attaching strap.
- Note attaching strap routing for correct installation.

6. Remove the safety belt anchor bolt.
- To install, tighten to 55 Nm (41 lb-ft).

7. Remove the 2 pin-type retainers and lower panel.

8. Release the 3 lower J-clips and route the RH flap through the child safety seat anchorage.





9. Detach the 2 J-clips and remove the attaching straps.

10. Remove the safety belt guide cover.
- Insert an appropriate tool into the holes and release the 3 locking tabs.

- Detach the safety belt guide cover.

- Route the safety belt webbing through the slot.

11. Remove the latch release handle bezel.
- Release the upper tab and separate the bezel from the latch release handle.

12. NOTICE: Use care when separating the backrest cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the backrest foam pad.

Partially invert the backrest cover to the row of hog rings.

13. Remove all hog rings and backrest cover.
- Route the safety belt webbing through the backrest cover opening.

14. NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

To install, reverse the removal procedure.