Brake Shift Interlock Actuator - Column Shift

Brake Shift Interlock Actuator - Column Shift









Removal and Installation

1. Apply the park brake.

2. NOTICE: To prevent damage to the selector lever boot, do not pull out on the top of the boot frame.

Remove the selector lever boot from the steering column shroud by pressing in on the selector lever boot frame.





3. Position the selector lever boot up the selector lever.





4. NOTE: Steering wheel removed for clarity.

Unsnap and remove the upper steering column shroud from the lower shroud.





5. Pull back on the brake shift interlock plunger, apply the brake pedal and shift the transmission into NEUTRAL.





6. Disconnect the Brake Shift Interlock Actuator (BSIA) electrical connector.





7. Remove the BSIA screw.





8. Gently pry the clip up and remove the BSIA.

9. NOTE: When installing the BSIA, verify that the BSIA override has been activated and the slider is fully rearward. Before rotating the selector lever from NEUTRAL into PARK, align the selector lever tab into the BSIA.

To install, reverse the removal procedure.