Hydraulic Booster to Steering Gear Pressure Line

Hydraulic Booster to Steering Gear Pressure Line













Removal and Installation

NOTICE: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power steering components may result.

NOTE: The hydraulic booster jumper line and the pressure line can be serviced separately. It is not necessary to disconnect the jumper line from the hydraulic booster when servicing the pressure line.

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Using a suitable suction device, remove the power steering fluid from the fluid reservoir.

3. NOTE: Thoroughly clean all foreign material from the threads.

Disconnect the pressure line-to-hydraulic booster jumper line fitting.

- To install, tighten to 63 Nm (46 lb-ft).


4. NOTE: Thoroughly clean all foreign material from the threads.

Disconnect the pressure line-to-steering gear fitting and remove the pressure line.

- To install, tighten to 20 Nm (177 lb-in).


5. To install, reverse the removal procedure.

6. Fill the power steering system.