Head Restraint - Front Passenger, With DVD

Head Restraint - Front Passenger, With DVD

Removal

1. Separate the backrest cover lower J-clips and open the zippers on both sides.





2. Detach the pin-type retainer and remove the wires from the retainer.





3. Disconnect the 2 DVD player electrical connectors in the following sequence.
1. Remove the insulation from around the security clamps.

2. Open the top of the security clamps.

3. Disconnect the electrical connectors.


4. Push in on the 2 head restraint guide sleeve buttons and remove the head restraint.
- Route the wires out of the seat.






Installation

1. Route the DVD player wires into the head restraint guide sleeves.





2. Push in on the 2 head restraint guide sleeve buttons while installing the head restraint.
- Position the head restraint to its highest locking position.


3. Connect the 2 DVD player electrical connectors in the following sequence.
1. Connect the 2 white DVD player electrical connectors together.

2. Connect the 2 black DVD player electrical connectors together.

3. Close the top of the security clamps.

4. Wrap the insulation around the security clamps.


4. Secure the DVD player wires in the following sequence.
1. Put the wires in the retainer.

2. Attach the pin-type retainer to the backrest.

3. Secure the retainer around the wires.






5. Make sure the head restraint adjusts without excessive effort.

6. Close the backrest cover zippers and attach the lower J-clips.

7. Carry out the Occupant Classification Sensor (OCS) System Reset. For additional information, refer to the General Procedures portion of Restraints and Safety Systems &/or Air Bag Systems.