Ignition Switch: Testing and Inspection

SRS components are located in this area. Review the SRS component locations, precautions, and procedures before performing repairs or service.

1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons ('99 - 00 models).
2. Disconnect the battery negative cable.
3. Remove the driver's dashboard lower cover and knee bolster.
4. Disconnect the 5P connector from the under-dash fuse/relay box and the 7P connector from the main wire harness.




5. Check for continuity between the terminals in each switch position according to the table.
6. If the continuity checks do not agree with the table, replace the electrical switch.