DTC 14-4
DTC 14-4: Faulty Power Supply to the Front Passenger's Side Impact Sensor1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.
Does the SRS indicator stay on?
YES - Go to step 3.
NO - Intermittent failure, system is OK at this time Go to Troubleshooting Intermittent Failures.
3. Turn the ignition switch OFF Disconnect the battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's side airbag and front passenger's side airbag 2P connectors (A).
5. Disconnect the right side wire harness 2P connector (A) from the front passenger's side impact sensor (B).
6. Disconnect SRS unit connector B (18P) from the SRS unit.
7. Check resistance between the No.9 terminal of SRS unit connector B (18P) and body ground. There should be an open circuit, or at least 1 MOhm.
Is the resistance as specified?
YES - Go to step 8.
NO - Go to step 9.
8. Check resistance between the No.9 and No.16 terminals of SRS unit connector B (18P). There should be an open circuit, or at least 1 MOhm.
Is the resistance as specified?
YES - Faulty front passenger's side impact sensor or SRS unit; replace the front passenger's side impact sensor. If the problem is still present, replace the SRS unit.
NO - Go to step 11.
9. Disconnect the SRS floor subharness 28P connector (A) from the SRS floor harness 28P connector C852 (B).
10. Check resistance between the No.28 terminal of the SRS floor subharness 28P connector and body ground. There should be an open circuit, or at least 1 MOhm.
Is the resistance as specified?
YES - Short to ground in the SRS floor harness; replace the SRS floor harness.
NO - Short to ground in the SRS floor subharness or right side wire harness; replace the faulty harness.
11. Disconnect the SRS floor subharness 28P connector (A) from the SRS floor harness 28P connector C852 (B)
12. Check resistance between the No.28 and No.27 terminals of the SRS floor subharness 28P connector. There should be an open circuit, or at least 1 MOhm.
Is the resistance as specified?
YES - Short in the SRS floor harness; replace the SRS floor harness.
NO - Short in the SRS floor subharness or right side wire harness; replace the faulty harness.