Engine Mount Control Solenoid: Testing and Inspection
Engine Mount Control SystemTroubleshooting
Special Tools Required
Vacuum pump/gauge, 0-30 in.Hg
A973X-041-XXXXX
NOTE: Check the vacuum hoses and lines for damage and proper connections before troubleshooting.
Follow this procedure if the engine vibrates excessively when idling.
1. Warm up the engine to normal operating temperature (the cooling fan comes on two times).
Is the idle speed less than 730 rpm?
YES - Go to step 2.
NO - Adjust the idle speed.
2. Fully depress the brake pedal.
3. With the transmission in gear, have an assistant disconnect and reconnect the 2P connector at the engine mount control solenoid valve.
Is there a noticeable change in idle smoothness when the 2P connector is disconnected?
YES - Reconnect the 2P connector to the solenoid valve. The engine mount control system is OK.
NO - Go to step 4.
4. Shift the transmission to Park or Neutral.
5. Disconnect the 2P connector from the engine mount control solenoid valve.
6. Measure voltage between the No.2 terminal and body ground.
Is there battery voltage?
YES - Go to step 7.
NO - Repair open in the wire between the engine mount control solenoid valve connector and No.6 (15A) fuse in the under-dash driver's fuse/relay box.
7. Measure voltage between the engine mount control solenoid valve 2P connector No.1 terminal and No.2 terminal.
Is there battery voltage?
YES - Go to step 8.
NO - Repair open in the wire between PCM connector terminal E24 and the engine mount control solenoid valve connector. If the wire is OK, substitute a known-good PCM and recheck.
8. Raise the engine speed above 1,000 rpm.
9. Measure voltage between the engine mount control solenoid valve 2P connector No.1 terminal and No.2 terminal.
Is there battery voltage?
YES - Repair short to body ground in the wire between PCM connector terminal E24 and the engine mount control solenoid valve connector. If the wire is OK, substitute a known-good PCM and recheck.
NO - Go to step 10.
10. Connect the engine mount control solenoid valve 2P connector.
11. Disconnect the upper vacuum hose (A) from the engine mount control solenoid valve (B), and connect a vacuum pump/gauge to the hose. Apply vacuum for 20 seconds.
Does the engine mount hold vacuum?
YES - Go to step 12.
NO - Either the vacuum hose or front engine mount has a vacuum leak. Repair as needed.
12. Release the vacuum, then apply vacuum again.
Is there a noticeable change in idle smoothness with and without vacuum applied?
YES - Go to step 13.
NO - Replace the front engine mount.
13. Disconnect the upper vacuum hose (A) from the engine mount control solenoid valve (B) and connect a vacuum pump/gauge to the hose.
Is there manifold vacuum at idle, and a decrease in manifold vacuum when engine speed is above 1,000 rpm?
YES - Engine mount control system is OK at this time. Check the engine mount if necessary.
NO - Replace the engine mount control solenoid valve.