Reverse Shift Fork Clearance Inspection

Inspection





1. Measure the clearance between the reverse idler gear (A) and the reverse shift fork (B) with a feeler gauge (C). If the clearance is more than the service limit, go to step 2.
Standard: 0.20 - 0.59 mm (0.007 - 0.023 inch)
Service Limit: 1.2 mm (0.047 inch)





2. Measure the width of the reverse shift fork.
^ If distance is not within the standard, replace the reverse shift fork with a new one.
^ If distance is within the standard, replace the reverse gear with a new one.
Standard: 13.4 - 13.7 mm (0.527 - 0.539 inch)