Trim Removal/Installation - Rear Side Pillar Area
Trim Removal/Installation - Rear Side Pillar AreaSpecial Tools Required
KTC trim tool set SOJATP2014 *
*Available through the American Honda Tool and Equipment Program;
NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to bend or scratch the trim and panels.
Quarter Pillar Trim
1. Remove the quarter pillar trim as shown. To remove the trim, remove the upper portion of the rear side trim panel as needed.
2. Install the trim in the reverse order of removal, and note these items:
- Check for damaged or stress-whitened clips, and replace them with new ones.
- When installing the rear side trim panel, make sure the seat belt is not pinched.
- Push the clips into place securely.
D-Pillar Trim/Rear Roof Trim
1. Remove these items, then remove the trim as shown:
- Quarter pillar trim
- Upper portion of the rear side trim panel as needed
- Rear ceiling light
2. Install the trim in the reverse order of removal, and note these items:
- Check for damaged or stress-whitened clips, and replace them with new ones.
- Apply liquid thread lock to the upper anchor bolt before installation.
- Push the clips into place securely.
- When installing the rear side trim panel, make sure the seat belt is not pinched.
- Before installing the upper anchor bolt, make sure there are no twists or kinks in the seat belt.