Clutch Pressure Control Solenoid Valve C Replacement
A/T Clutch Pressure, Control Solenoid Valve C.Replacement1. Disconnect the connector from. A/T clutch pressure control solenoid valve C.
2. Remove A/T clutch pressure control solenoid valve C.
3. Clean the mounting surface and fluid passage of A/T clutch pressure control solenoid valve C and the transmission housing.
4. Install the 8 x 12 mm ATF feed pipe (A) with its filter side into the transmission housing.
5. Install the new gasket (B) in the mounting groove of the A/T clutch pressure control solenoid valve C body properly, then install them on the transmission housing. Do not pinch the gasket
6. Check the solenoid connector for rust, dirt, or oil. Clean as necessary, then reconnect the connector.