End Cover Disassemble & Service
End CoverATF Feed Pipe Replacement
1. Remove the feed pipe flange plates (A), then remove the feed pipes (B) and feed pipe flanges (C) from the end cover (D).
NOTE: Replace the end cover if replacement of the undetectable ATF feed pipes (E) is required.
2. Install new O-rings (F) over the ATF feed pipes.
3. Install new O-rings (G) on the feed pipe flanges.
4. Install the feed pipe (A) through the feed pipe flange (B) by aligning the feed pipe tab (C) with the guide (D) on the flange.
5. Install the ATF feed pipe over the undetectable feed pipe (E), and align the mark (F) on the feed pipe flange between the tabs (G) on the end cover.
6. Install the feed pipe flange plate.