Door Position
Rear Door Position AdjustmentSRS components are located in the lower B-pillar area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE: Check for a flush fit with the body, then check for equal gaps between the front, rear, and bottom door edges and the body. Check that the door and body edges are parallel.
1. Place the vehicle on a firm, level surface when adjusting the doors.
2. Adjust at the hinges (A):
- Pad a floor jack (B) with shop towels (C), then use the jack to support the door to prevent damage to the door while adjusting it.
- Loosen the door mounting bolts (D) slightly, and move the door in or out until it's flush with the body.
- Remove these items:
- C-pillar outer trim
- Rear cladding
- Quarter pillar trim
- Loosen the hinge mounting bolts (E) and nut (F) slightly, and move the door backward or forward, up or down as necessary to equalize the gaps.
3. Close the rear door, and check that it latches securely without slamming it, and the rear door and body edges are parallel. If necessary, adjust the upper and lower striker at the same time.
4. Close the front door, and make sure it latches securely without slamming it, and the front door, rear door, and body edges are parallel.
5. After adjusting the upper and lower strikers, check the rear door unlock synchronization. If necessary, adjust the upper and lower latch cables.
6. Apply touch-up paint to the hinge mounting bolts, and around the hinges.
7. Check for water leaks.
8. Test-drive and check for wind noise.