Operation CHARM: Car repair manuals for everyone.

ABS Indicator, Brake System Indicator, and VSA Indicator Do Not Go Off at Same Time

ABS indicator, brake system indicator, and VSA indicator do not go off at same time

NOTE: Check for gauges DTCs with the HDS. If gauges DTCs are stored, troubleshoot those DTCs first.

1. Release the parking brake.
2. Turn the ignition switch ON (II).
3. Check the ABS indicator, the brake system indicator, and VSA indicator for several seconds when the ignition switch is turned ON (II).
Do the indicators come on then go off?
YES - Intermittent failure, the system is OK at this time. Check for loose terminals between the gauge control module 36P connector and the VSA modulator-control unit 47P connector. Refer to intermittent failures troubleshooting.
NO - Go to step 4.

4. Turn the ignition switch OFF.
5. Short the SCS line with the HDS.
6. Disconnect ECM/PCM connector E (31P).
7. Disconnect the gauge control module 36P connector.
8. Disconnect the VSA modulator-control unit 47P connector.
9. Check for continuity between the VSA modulator-control unit 47P connector terminals No. 11, and No. 15 and body ground individually.





Is there continuity?
YES - Repair the short to body ground on the appropriate wire.
NO - Go to step 10.

10. Check for continuity between VSA modulator-control unit 47P connector terminals No. 11 and No. 15.





Is there continuity?
YES - Repair short in the wire between VSA modulator-control unit 47P connector terminals No. 11 (CAN1-L line) and No. 15 (CAN1-L line).
NO - Go to step.

11. Check for continuity between VSA modulator-control unit 47P connector terminal and gauge control module 36P connector terminal (see table).





Is there continuity?
YES - Check for loose terminals in the gauge control module 36P connector. If necessary, substitute a known-good gauge control module, then go to step 1 and recheck. If it is OK, replace the original gauge control module. If DTCs are indicated, replace the VSA modulator-control unit.
NO - Repair open in the wire between the gauge control module and the VSA modulator-control unit.