Audio Unit Removal/Installation

Audio Unit Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.

NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the dashboard and related parts.
- Lay a workshop towel under the parts when working on them to protect the face panel from scratches or other damage.

With navigation

1. Make sure you have the anti-theft codes for the audio and navigation system, then write down the audio presets.
2. Remove the center panel.




3. Remove the bolts, then pull out the audio unit (A).
4. Disconnect the connectors (B), then remove the audio unit.




5. Remove the bolts, and the bracket (A).
6. Install the audio unit in the reverse order of removal, and note these items:
- Make sure all connectors and AM/FM antenna sublead are secure.
- Enter the anti-theft codes for the audio system, then enter the audio presets, and set the clock.
- If necessary, enter the navigation system code.

Without navigation

1. Make sure you have the anti-theft codes for the audio system, then write down the audio presets.
2. Remove the center panel.







3. Remove the bolts, then pull out the audio unit (A).
4. Disconnect the connectors (B), then remove the audio unit.




5. Remove the bolts, and the bracket (A).
6. Install the audio unit in the reverse order of removal, and note these items:
- Make sure all connectors and AM/FM antenna sublead are secure.
- Enter the anti-theft code for the audio system, then enter the audio presets, and set the clock.