DTC 32-1x

DTC 32-1x ("x" can be 0 thru 9 or A thru F) Open or Increased Resistance in Front, Passenger's Side Airbag Inflator

Special Tools Required
- SRS inflator simulator 07SAZ-TB4011A
- SRS simulator lead E 07XAZ-SIA0200

1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on, and is DTC 32-1x indicated?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. Troubleshooting Intermittent Failures If another DTC is indicated, go to the DTC Troubleshooting Index. DTC List - Supplemental Restraint System

3. Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes.




4. Disconnect the SRS harness 2P connector (A) from the front passenger's side airbag (B).
5. Connect the SRS inflator simulator (2 ohm connector) and simulator lead E to the SRS harness.
6. Reconnect the negative cable to the battery.
7. Erase the DTC memory.
8. Check for a DTC.

Is DTC 32-1x indicated?

YES - Go to step 9.

NO - Open or increased resistance in the front passenger's side airbag inflator, replace the front passenger's side airbag.

9. Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes.
10. Disconnect SRS unit connector C (28P) from the SRS unit.
11. Disconnect the SRS inflator simulator from the SRS simulator lead. Do not disconnect the simulator lead from the SRS harness 2P connector.




12. Check resistance between the terminals of the SRS simulator lead. There should be less than 1.0 ohm.

Is the resistance as specified?

YES - Faulty SRS unit or poor connection at SRS unit connector C (28P) and the SRS unit. Check the connection if the connection is OK, replace the SRS unit.

NO - Go to step 13.




13. Disconnect SRS harness 28P connector C854 (A) from SRS subharness connector C854 (B).




14. Check resistance between the No. 23 and No. 24 terminals of SRS subharness 28P connector C854. There should be less than 1.0 ohm.

Is the resistance as specified?

YES - Open or increased resistance in the SRS harness replace the SRS harness.

NO - Open or increased resistance in the SRS subharness replace the SRS subharness.