Drivers Dashboard Lower Cover Removal/Installation

Driver's Dashboard Lower Cover Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*

NOTE:

- Put on gloves to protect your hands.

- Take care not to scratch the dashboard and related parts.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Open the front door, and remove the driver's dashboard side cover (A).
-1 Pull out the front door opening trim (B), as needed.
-2 Pry up on the lower edge of the dashboard side cover at the notch (C) to release the clip (D).
-3 Gently pull out along the edge to release the clips (E).






2. Remove the driver's dashboard lower cover (A).
-1 Remove the screw from the driver's dashboard lower cover.
-2 Pull out the bottom of the driver's dashboard lower cover to release the clips and hooks (B).
-3 Disconnect the VSA OFF switch connector (C), the front fog light switch connector (D) if equipped, the in-car temperature sensor connector (E), and the air hose (F).

3. Install the cover in the reverse order of removal, and note these items:
- Make sure all connectors are plugged in properly, and the air hose is connected properly.

- If the clips are damaged or stress-whitened, replace them with new ones.

- Push the clips and hooks into place securely.