Driver's Power Seat Motor Test (RTS, RTL, and EXL models)

Driver's Power Seat Motor Test

1. Remove the driver's seat. Front Seat Removal/Installation

2. Remove the power seat adjustment switch knobs and recline cover from the seat. Front Seat Cushion Cover Replacement

3. Disconnect the 12P connector (A) from the power seat adjustment switch (B).






4. Test each motor by applying battery voltage and body ground to the 12P connector terminals.

5. If the motor does not run or fails to run smoothly, check for an open in the driver's seat wire harness and recline motor subharness. If the harness is OK, replace the motor.
- Recline motor Front Seat-Back Cover Replacement

- Other motors Front Seat Linkage Disassembly/Reassembly - Driver's 10-Way Power

Slide motor





Recline motor





Front up-down motor





Rear up-down motor