Torque Converter Housing Countershaft Bearing Replacement

Torque Converter Housing Countershaft Bearing Replacement

Special Tools Required

- Adjustable bearing puller, 25-40 mm 07JAC-PH80000
- Weight, remover 07741-0010201
- Driver handle 15 x 135L 07749-0010000
- Attachment, 78 x 80 mm 07NAD-PX40100
1. Remove the countershaft bearing from the torque converter housing with the adjustable bearing puller and weight, remover.






2. Install the ATF guide plate (A) into the housing, then install a new bearing (B) in the direction shown.






3. Install the bearing (A) in the housing with the driver handle and the attachment (78 x 80 mm); install the bearing outer race notch-cut (B) to a depth (C) of 0-0.03 mm (0-0.001 in.) below the housing surface (D).