FM Distributor Removal And Installation

FM Distributor Removal and Installation

Removal

1. Inner Vent - Both Sides

1. Carefully pry out the inner vents (A) with the appropriate trim tool to detach the clips (B), then remove the inner vents.

2. Audio-Navigation Unit Assembly

Except KX

NOTE:
* Eject the discs before removing the audio-navigation unit to prevent damaging the CD/DVD player's load mechanism.
* If you are replacing the audio-navigation unit, write down the audio presets (if possible), then enter them into the new audio-navigation unit.
* If the audio-navigation unit is replaced or disconnected, Map Matching must be done.
* Lay a shop towel under the parts when working on them to protect the face panel from scratches or other damage.
* Do not work in a dusty or dirty place.
* Discharge static electricity from your body before and during the work.
* Do not touch the circuit board(s) with your bare hands.
* Do not work with dirty hands.
* Do not touch the terminal connector of the flat plate cable with your bare hands (If you have touched it, wipe it off thoroughly.).

1. Remove the bolts.

2. Disconnect the connectors, then pull out the audio-navigation unit (A).

3. FM Distributor Assembly

1. Disconnect the connectors.

2. Remove the FM distributer assembly (A).

Installation

1. FM Distributor Assembly

1. Install the FM distributer assembly (A).

2. Connect the connectors.

2. Audio-Navigation Unit Assembly

Except KX

1. Connect the connectors, then install the audio-navigation unit (A).

NOTE: Make sure all the connectors and the antenna lead are secure.

2. Install the bolts (B).

3. Inner Vent - Both Sides

1. Install the inner vents (A). Make sure the clips (B) snap into place securely.