Driver's Power Seat Motor Test (With DPMS)

Driver's Power Seat Motor Test

NOTE: SRS components are located in this area. Review the SRS component locations Locations, and precautions and procedures Service Precautions before doing repairs or servicing.

1. Remove the driver's seat Removal and Replacement.

2. Disconnect the 5P connector from each power seat motor.

NOTE:

- For the recline motor, remove the seat-back cover Service and Repair.
- All connectors are terminal side of male terminals.










3. Test each motor by connecting power and ground according to the table. When the motor stops running, disconnect battery power immediately.





4. If the motor does not run or fails to run smoothly, replace the motor:

- Slide motor Front Seat Slide Motor Replacement
- Front up-down motor/seat frame Front Seat Frame Replacement
- Rear up-down motor/seat frame Front Seat Frame Replacement
- Recline motor Front Seat Recline Motor Replacement

NOTE: Replace the front or rear up-down motors/seat frame as an assembly.