A/T Clutch Pressure Control Solenoid Valve C Replacement (5-Speed A/T)

A/T Clutch Pressure Control Solenoid Valve C Replacement

1. Remove the air intake scoop.

2. Do the battery removal procedure.

3. Remove the air cleaner Service and Repair.

4. Remove the intake air duct.

5. Remove the main under-hood fuse box.

6. Remove the battery base.

7. Disconnect the A/T clutch pressure control solenoid valve C connector (A).





8. Remove A/T clutch pressure control solenoid valve C, the 8 x 53 mm ATF pipe (B), the 8 x 36 mm ATF pipe (D), the O-rings (E), the 8 x 25.2 mm ATF joint pipe (F), and the gasket (G).

9. Clean the mounting surfaces and the fluid passages of the transmission housing.

10. Install the 8 x 53 mm ATF pipe (A) with the filter end into its mounting hole (B).






11. Check the height (A) of the 8 x 53 mm ATF pipe (B) between the top (C) of the pipe and the solenoid valve body mounting surface (D). The height is about 7 mm (0.28 in). If the height is over 7 mm (0.28 in), push the pipe until it bottoms in the accumulator body.






12. Install a new gasket (A) on the transmission housing, and install the 8 x 36 mm ATF pipe (B) with the filter end into the transmission housing and the 8 x 25.2 mm ATF joint pipe (D).





13. Install new O-rings (E) over the ATF pipes.

14. Install A/T clutch pressure control solenoid valve C.

15. Check the connector for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.

16. Install the battery base.

17. Install the main under-hood fuse box.

18. Install the intake air duct.

19. Install the air cleaner Service and Repair.

20. Do the battery installation procedure.

21. Install the air intake scoop.