Rear

DISASSEMBLY





- Put matchmarks, on coil spring and shock absorber.





1. Set shock absorber in vise with attachment, then loosen piston rod lock nut.

WARNING: Do not remove piston rod lock nut at this time.

2. Compress spring with tool so that the shock absorber upper spring seat can be turned by hand.

WARNING: Make sure that the pawls of the two spring compressors are firmly hooked on the spring. The spring compressors must be tightened alternately so as not to tilt the spring.

3. Remove piston rod lock nut.

INSPECTION
Shock absorber assembly
- Check for smooth operation through a full stroke, both compression and extension.
Check for oil leakage occurring on welded or gland packing portions.
- Check piston rod for cracks, deformation or other damage.
Replace if necessary.

Upper rubber seat and bushing
Check rubber parts for deterioration or cracks. Replace if necessary.

Coil spring
Check for cracks, deformation or other damage. Replace if necessary.

ASSEMBLY





- Install upper spring seat with its cutout facing the outer side of vehicle.





- When installing coil springs, be careful not to reverse top and bottom direction. (Top end is flat.)
- When installing coil spring on shock absorber, it must be positioned as shown in figure.