Body - Quarter Glass Moulding is Not Flat

Classification:
BT07-039

Reference:
ITB07-043

2008 G37 COUPE; QUARTER GLASS MOLDING IS NOT FLAT

APPLIED VEHICLE:
2008 G37 Coupe (CV36)

APPLIED VIN:
Built before JNKCV64E(*)8M 107984

APPLIED DATE:
Built before September 10, 2007

IF YOU CONFIRM





The front end of the quarter glass molding is lifted and will not stay flat to the body (left and/or right side).

ACTION

Cut about 1/16 inch (2 mm) off of the front edge of the molding as shown in the Service Procedure.

CLAIMS INFORMATION





Submit a Primary Part (PP) type line claim using the claims coding shown.

IMPORTANT:
The purpose of "ACTION" (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire Service Procedure as it contains information that is essential to successfully completing this repair.

SERVICE PROCEDURE





1. Cut off about 1/16 inch (2 mm) of rubber from the front edge of the molding as shown in Figure 2.

^ Use a sharp cutting tool so you will have a clean cut edge.

2. Tape the molding in place for about 20 minutes to "set" the molding in the down (flat) position.

^ Use auto body painters tape.

3. Remove the tape and make sure the molding stays flat to the body.





Disclaimer