Removal and Installation

LUGGAGE FLOOR TRIM


Removal and Installation


REMOVAL

LUGGAGE REAR PLATE
1. Fully open back door.
2. Remove tonneau cover assembly.





3. Open and pull luggage finisher center (1) backwards, till the bolts are visible.
4. Remove both bolts and then remove luggage finisher center.





5. Remove luggage side finisher lower fixing bolts (LH/RH) with a remover tool (A).
6. Remove back door weather strip.





7. Remove luggage rear plate (1) fixing clips with remover tool.
8. Hold both sides of luggage rear plate, pull upwards to remove.
9. Remove the bolts located inside the luggage floor spacer and remove luggage floor spacer. (LH/RH)
10. Open the rear plate cap (1) at approximately 90 degree, then pull it up to remove from the rear plate (2) as shown by the figure below.






LUGGAGE SIDE FINISHER UPPER
1. Remove rear seat belt anchor bolt (upper).
2. Remove luggage side finisher lower.
3. Remove tonneau cover and remove the luggage side finisher upper fixing bolts and clips.





4. Remove luggage side upper finisher clips, pawls and metal clips with remover tool (A).
5. Remove luggage side upper finisher (1) from the body side panel.

LUGGAGE SIDE FINISHER LOWER
1. Remove rear kicking plate inner and rear body side welt. Refer to Body Side Trim.
2. Remove rear seat cushion fixing bolts. Refer to Removal and Installation.
3. Remove luggage rear plate.





4. Disengage rope hook mounting bolt caps, and remove rope hook mounting bolts with socket wrench (A), and then remove rope hooks (1) (LH/RH).
5. Remove the luggage side finisher lower room lamp. Refer to Removal and Installation.





6. Remove the luggage side finisher lower switch escutcheon (1)
(LH/RH).
7. Remove luggage side finisher lower fixing clips and hooks with remover tool.
8. Pull the luggage side finisher lower to disengage the clips and metal clips.
9. Remove luggage side lower finisher.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
Check that clips, pawls, metal clips are securely fitted in panel holes on body when installing, and then press them in.