Removal and Installation

LUGGAGE FLOOR TRIM


Removal and Installation


REMOVAL

LUGGAGE REAR PLATE
1. Fully open back door.
2. Remove tonneau cover assembly.





3. Open and pull luggage finisher center (1) backwards, till the bolts are visible.
4. Remove both bolts and then remove luggage finisher center.





5. Remove the clip (A), disconnect the woofer harness connector
(B), and then remove the woofer (1) and spire tire (2). Refer to Navigation (Twin Monitor).
6. Remove the rear seat assembly. Refer to Removal and Installation.
7. Remove the luggage floor finisher front (LH/RH).
8. Remove back door weather-strip.





9. Disengage the rear plate (1) fixing clips with a remover tool (A) then remove it.
10. Hold both sides of luggage rear plate, pull upwards to remove.

LUGGAGE FLOOR SPACER
1. Disconnect the harness connector (A), remove the bolts shown by the arrows in the figure below, then remove the luggage floor spacer (1) (RH/LH).





2. Remove the bolts located inside the luggage floor spacer and then remove luggage floor spacer. (RH/LH)

LUGGAGE SIDE FINISHER LOWER
1. Remove rear kicking plate inner and rear body side welt. Refer to Body Side Trim.
2. Remove rear seat assembly fixing bolts. Refer to Exploded View.
3. Remove luggage rear plate.
4. Remove luggage floor spacers (LH/RH).





5. Disengage rope hook mounting bolt caps, and remove rope hook mounting bolts with socket wrench (A), and then remove rope hooks (1) (LH/RH).
6. Remove seatback control cable finisher (1) fixing bolt (A), then remove the seatback control cable finisher (LH/RH).





7. Remove the luggage room lamp (RH). Refer to Removal and Installation.
8. Remove luggage side finisher lower fixing clips with remover tool.





9. Pull the luggage side finisher lower (1) to disengage the clips and metal clips, then disconnect the luggage room power socket harness connector (A).
10. Remove luggage side finisher lower.

LUGGAGE SIDE FINISHER UPPER
1. Remove rear seat belt floor anchor bolt.
2. Remove luggage side finisher lower.
3. Remove the rear seat belt finisher.





4. Remove luggage side upper finisher clips and pawl with remover tool (A).
5. Disconnect the rear squawker harness connector and then remove the rear squawker. Refer to Navigation (Twin Monitor).
6. Remove luggage side finisher upper (1) from the body side panel.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
Check that clips, pawls, metal clips are securely fitted in panel holes on body when installing, and then press them in.