Rear Vision Camera: Adjustments

REAR VIEW CAMERA


Adjustment






1. Draw lines on rearward area of the vehicle passing through the following points: 200 mm (7.87 in) from both sides of the vehicle, and 0.5 m (1.64 ft), 1.0 m (3.28 ft) from the rear end of the bumper.
2. Set into "Adjust offset of rear view camera" mode of Confirmation/Adjustment mode.





3. Rotate the center dial, and then select the guiding line pattern so that its angle is aligned with the correction line of the rear of the vehicle.

Selected pattern : 7

4. Fine adjust the guiding line so that its position is aligned to the correction line by pressing the up/down/left/right switches.
Pressing "ENTER" enable the camera control unit to memory the adjusted guiding line position.

Up/Down adjustment range : -20 - 20
Left/Right adjustment range : -20 - 20

CAUTION:
After the adjustment, never perform other operations for one minute.