Removal And Installation

CONDENSER


CONDENSER : Removal and Installation


REMOVAL
1. Remove condenser pipe assembly. Exploded View.
2. Remove ambient sensor. Exploded View.
3. Remove gas sensor (WITH ACCS). Exploded View.





4. Remove harness clips (A).
5. Remove mounting bolts (B) and nut (C), and then remove hood lock stay assembly (1).
6. Disconnect refrigerant pressure sensor connector (A) and harness clips (B).










7. Pull condenser (1) upward of vehicle, and then remove condenser (as shown in the figure).

Circle: Pawl


CAUTION:
Be careful not to damage core surface of condenser.

INSTALLATION
Installation is basically the reverse order of removal.

CAUTION:
- Replace O-rings with new ones. Then apply compressor oil to them when installing.
- Female-side piping connection is thin and easy to deform. Slowly insert the male-side piping straight in axial direction.
- Insert piping securely until a click is heard.
- After piping connection is completed, pull male-side piping by hand to make sure that connection does not come loose.
- Check for leakages when recharging refrigerant.