Sunroof / Moonroof: Service and Repair

Sunroof Glass

Removal

1. Tilt the sunroof and open the sunshade.
2. Disconnect the battery ground cable.
3. Pull out the front of sight shield (2).




4. Remove four sunroof glass fixing TORX screws (3) to remove the sunroof glass (1).

Installation

1. Be sure to install the sunroof weatherstrip so that the joint of the weatherstrip is on the rear side of the vehicle.

2. Temporary install the glass to the sunroof frame.

3. Open and shut the sunroof four to five times to position correctly the sunroof weatherstrip and the glass in the longitudinal and latitudinal setting positions.

4. Adjust the setting position to flush the surface between the roof panel and weatherstrip of sunroof glass.

5. Tighten the sunroof glass fixing screws to the specified torque.
Torque: 4 N.m (35 lb in)

6. Inspect the sunroof alignment after installing the sunroof glass. Use the fixing screws to adjust the sunroof if not aligned.