Rear Window Regulator, Glass and Glass Run
Rear Window Regulator, Glass and Glass RunParts Location:
Removal
1. Disconnect the battery ground cable.
2. Remove the pull box.
- Remove the fixing screw.
3. Remove the power window switch (1).
- Pull the power window switch and remove the connector.
4. Remove the inside handle.
- Open the screw cover and remove the screw.
- Disconnect the cable.
5. Pull the trim panel at the 7 clip positions.
- Disconnect the tweeter and courtesy light connectors.
6. Remove the inner waist seal.
7. Remove the tweeter and the courtesy light.
8. Remove the pull box bracket.
9. Remove the speaker and the speaker spacer.
- Disconnect the speaker harness connector.
10. Remove the inside lock bracket.
- Disconnect the cable.
11. Remove the waterproof sheet (1).
- Taking notice of the door harness, peel the waterproof sheet off the door panel carefully.
12. Remove the outer waist seal.
- Remove the front side screw and pull the waist seal upward.
13. Remove the window glass.
- Operate the regulator (power window switch) to adjust the glass hight and expose the access hole. Remove the 2 bolts fixing the bottom channel and the regulator. Remove the glass.
14. Remove the fixed window glass (2) by removing the screw from the top of the division bar (1) and the bolt from the bottom of the division bar.
15. Remove the window regulator.
- Remove the 6 fixing bolts and pull the regulator out from the lower hole of the door panel.
16. Remove the glass run.
- Pull the glass run from the door frame.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Check to see that the window regulator operates smoothly and the glass opens and closes properly.
2. Install the waterproof sheet tightly against the door panel.
3. Tighten the window regulator assembly fixing bolts to the specified torque.
Torque: 6 N.m (52 lb in)