Rear Wiper/Washer Switch Illumination Lamp

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, DRIVER AIRBAG, PASSENGER AIRBAG, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

REMOVAL
The rear wiper and washer switch in the accessory switch bezel of the instrument panel includes a single serviceable incandescent illumination bulb and bulb holder unit.
1. Disconnect and isolate the battery negative cable.
2. Remove the rear wiper and washer switch from the accessory switch bezel. (Refer to ELECTRICAL/REAR WIPERS/WASHERS/REAR WIPER/WASHER SWITCH - REMOVAL).

Fig. 3 Rear Wiper/Washer Switch Illumination Lamp:

3. From the bottom of the switch housing, use a small thin-bladed screwdriver to rotate the switch illumination bulb holder counterclockwise about 30 degrees in the bulb mounting hole.
4. Pull the rear wiper/washer switch illumination bulb holder and bulb unit straight out of the bulb mounting hole.

INSTALLATION
The rear wiper and washer switch in the accessory switch bezel of the instrument panel includes a single serviceable incandescent illumination bulb and bulb holder unit.

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket and/or the lamp wiring.

1. Align the rear wiper and washer switch illumination bulb holder and bulb unit with the bulb mounting hole in the bottom of the switch.
2. Insert the rear wiper and washer switch illumination bulb holder and bulb unit straight into the bulb mounting hole until it is firmly seated.
3. Using a small thin-bladed screwdriver, rotate the illumination bulb holder clockwise about 30 degrees in the bulb mounting hole.
4. Reinstall the rear wiper and washer switch into the accessory switch bezel. (Refer to ELECTRICAL/REAR WIPERS/WASHERS/REAR WIPER/ WASHER SWITCH - INSTALLATION).
5. Reconnect the battery negative cable.