Front Hub / Bearing - Installation

INSTALLATION





1. Install the hub bearing to the knuckle.
2. Install the hub bearing to knuckle and the 3 bolts (3) then tighten to 102 Nm (75 ft. lbs.).
3. Install the axle nut if equipped. Tighten to 136 Nm (100 ft. lbs.).




4. Install the wheel speed sensor (1) through the hole in the brake shield (2)Front Wheel Speed Sensor.




5. Install the wheel speed sensor (1) into the hub & bearing and install the mounting bolt (2). Tighten to 4-6 Nm (34-50 in. lbs.).




6. Install the brake rotor (3) Removal and Replacement.
7. Install the brake caliper adaptor (1) Removal and Replacement.
8. Install the caliper (1) Removal and Replacement.
9. Install the wheel and tire assembly Procedures.
10. Remove the support and lower the vehicle.