Brake Master Cylinder Reservoir - Installation

INSTALLATION






CAUTION: Do not use any type of tool to install the grommets (2). Tools may cut, or tear the grommets creating a leak problem after installation. Install the grommets using finger pressure only and insure that the grommets are properly seated and checked for leaks after installation.

1. Lubricate new grommets (2) with clean brake fluid and Install new grommets (2) onto reservoir outlets (1). Use finger pressure to install and seat grommets.





2. Start reservoir (1) and grommets into holes on master cylinder.





3. Then rock reservoir (1) back and forth while pressing downward to seat it in the holes on the master cylinder. Make sure the four tabs are securely seated over the nubs (3).





4. Install the fluid level sensor (2) if removed by just inserting the sensor in the reservoir until the tabs click.





5. Reconnect the electrical connector (3) to the fluid reservoir level switch.
6. Remove the prop rod from the vehicle.
7. Fill and bleed base brake system, Service and Repair.