Front Flare Assembly

FRONT FLARE ASSEMBLY

NOTE: Each flare is marked on the inside surface to identify the correct installation location.

Figure 6:

1. Position the front flare over the front of the running board. The top of the front flare will slide onto the front body flare (see figure 6).

2. Align the (3) front flare mounting holes over the corresponding vehicle mounting holes originally used for the mudguard. Loosely install the previously removed 10 mm mounting screws into their original position.

3. Adjust the front flare by pressing it firmly against the body flare in a position which allows no gap at the top. Tighten the mounting screws securely.