Upper Side Moulding / Trim: Service and Repair
ROOF DRIP SIDE FINISH MOULDINGRoof Drip Side Finish Moulding:
REMOVAL
1. REMOVE NO.2 ROOF DRIP SIDE FINISH CENTER MOULDING
2. REMOVE ROOF DRIP SIDE FINISH MOULDING
Using a moulding remover, remove the roof drip side finish moulding.
NOTE:
- Do not damage the body.
- Do not remove the No.2 roof drip side finish moulding clip.
- When the clip comes off, replace it with a new one.
HINT: Tape the moulding remover tip before use.
INSTALLATION
1. INSTALL NO.2 ROOF DRIP SIDE FINISH MOULDING CLIP
If the No.2 roof drip side finish moulding clips come off.
a. Using a heat light, heat the body mounting clip surface to 40 - 60 °C (104 - 140 °F).
NOTE: Do not heat the body excessively.
b. Remove the adhesive tape and adhesive from the body.
c. Wipe off stains with cleaner.
d. Using a heat light, heat the body and moulding clip.
Body: 40 - 60 °C (104 - 140 °F)
Moulding: 20 - 30 °C (68 - 86 °F)
NOTE: Do not heat the body and moulding excessively.
e. Install the clip.
2. INSTALL ROOF DRIP SIDE FINISH MOULDING
3. INSTALL NO.2 ROOF DRIP SIDE FINISH CENTER MOULDING