Rear Wiper Motor Assy
REPLACEMENT1. REMOVE REAR WIPER ARM ASSEMBLY
a. Remove the nut and the rear wiper arm.
2. REMOVE BACK DOOR GARNISH CENTER
3. REMOVE BACK DOOR SIDE GARNISH RH
4. REMOVE BACK DOOR SIDE GARNISH LH
5. REMOVE TOOL BOX PANEL SUB-ASSEMBLY UPPER
6. REMOVE DOOR PULL HANDLE SUB-ASSEMBLY
7. REMOVE BACK DOOR TRIM BOARD
8. REMOVE BACK DOOR SERVICE HOLE COVER
9. REMOVE REAR WIPER MOTOR ASSEMBLY
a. Remove the 3 bolts.
b. Disconnect the connector, and remove the rear wiper motor assembly.
10. INSTALL REAR WIPER MOTOR ASSEMBLY
a. Install the rear wiper motor assembly with the 3 bolts.
Torque: 5.5 Nm (56 kgf.cm, 49 in..lbf)
b. Connect the connector.
11. INSTALL REAR WIPER ARM ASSEMBLY
a. Scrape off the serration part of the wiper arm with a round file or equivalent.
b. Clean the rear wiper pivot serration with a wire brush.
c. Stop the rear wiper motor assembly at the automatic stop position. Install the rear wiper arm at the position as shown in the illustration.
Torque: 5.5 Nm (56 kgf.cm, 49 in.lbf)
12. INSTALL BACK DOOR SERVICE HOLE COVER