Overhaul
DISASSEMBLY1. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY (w/ Headlight Cleaner)
a. Remove the 2 screws and actuator.
2. REMOVE FRONT BUMPER ENERGY ABSORBER
3. REMOVE FRONT BUMPER REINFORCEMENT
a. Remove the 6 bolts and reinforcement.
4. REMOVE LASER RADAR SENSOR
a. Using a screwdriver, disconnect the wire harness clamp.
HINT: Tape the screwdriver tip before use.
b. Disconnect the sensor connector.
c. Remove the sensor.
5. REMOVE FRONT BUMPER STAY NO. 2
a. Remove the 3 screws and bumper stay.
6. REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET
a. Remove the 2 bolts and mounting bracket.
7. REMOVE FRONT BUMPER GARNISH
a. Remove the 2 bolts.
b. Using a screwdriver, remove the 7 clips and bumper garnish.
HINT: Tape the screwdriver tip before use.
8. REMOVE FOG LIGHT ASSEMBLY
a. Disengage the 2 claws and remove the fog light.
9. REMOVE FRONT BUMPER HOLE COVER
a. Using a screwdriver, disengage the 2 claws and remove the hole cover.
HINT: Tape the screwdriver tip before use.
10. REMOVE HEADLIGHT MOUNTING BRACKET
REASSEMBLY
1. INSTALL HEADLIGHT MOUNTING BRACKET
2. INSTALL FRONT BUMPER COVER
3. INSTALL FOG LIGHT ASSEMBLY
4. INSTALL FRONT BUMPER GARNISH
5. INSTALL FRONT BUMPER EXTENSION MOUNTING BRACKET
6. INSTALL FRONT BUMPER STAY NO. 2
7. INSTALL LASER RADAR SENSOR
8. INSTALL FRONT BUMPER REINFORCEMENT
a. Install the reinforcement with the 6 bolts.
Torque: 77 N.m (780 kgf.cm, 57 ft.lbf)
9. INSTALL FRONT BUMPER ENERGY ABSORBER
10. INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY (w/ Headlight Cleaner)