Without Scan Tool

DTC CHECK/CLEAR (WHEN USING SST CHECK WIRE)





a. DTC check
1 Using SST, connect terminals TC and CG of the DLC3.
SST 09843-18040
2 Turn the ignition switch on.





3 Read DTC from the ABS and VSC control warning lights on the combination meter.





HINT:
^ If no code appears, inspect the TC and CG terminal circuit, and ABS and VSC warning light circuits.
^ As an example, the illustration shows the blinking patterns of the normal system code and trouble codes 31 and 43, and display of the normal system code.

4 Codes are explained in the code table.
5 After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the display. If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.





b. DTC clear
1 Using SST, connect terminals TC and CG of the DLC3.
SST 09843-18040
2 Turn the ignition switch on.





3 Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.
4 Check that the ABS warning and brake control lights and multi information display indicate the normal system code.
5 Remove the SST from the terminals of the DLC3.

HINT: Clearing the DTCs cannot be performed by removing the battery cable or the ECU-IG NO. 1 fuse.

END OF DTC CHECK/CLEAR (WHEN USING SST CHECK WIRE)
a. Turn the ignition switch on.
b. Check that the ABS and brake control warning lights go off within approximately 3 seconds.