Installation

AXLE: REAR AXLE SHAFT: INSTALLATION

INSTALLATION

1. INSTALL REAR AXLE SHAFT





(a) Using SST and a press, install the rear axle shaft to the rear axle bearing assembly.
SST: 09521-25011
NOTE:
Do not damage the speed sensor rotor.

2. INSTALL REAR AXLE SHAFT SNAP RING





(a) Using a snap ring expander, install a new rear axle shaft snap ring.
3. INSTALL REAR AXLE SHAFT OIL SEAL





(a) Using SST and a hammer, install a new axle shaft oil seal.
SST: 09950-60020
09951-00770
SST: 09950-70010
09951-07150
4. INSTALL REAR AXLE SHAFT WITH BACKING PLATE





(a) Install a new O-ring.
(b) Install the rear axle shaft with backing plate with the 4 nuts.
Torque: 120 Nm (1,224 kgf-cm, 89 ft-lbf)
NOTICE:
- Do not damage the speed sensor rotor.
- Inspect no damage and no foreign matter at the speed sensor rotor.

5. INSTALL PARKING BRAKE SHOE Reassembly
6. INSTALL PARKING BRAKE SHOE STRUT
7. INSTALL PARKING BRAKE SHOE STRUT COMPRESSION SPRING
8. INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING Reassembly
9. INSTALL REAR DISC
10. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY
HINT: Installation

11. INSTALL REAR SPEED SENSOR (w/ ABS) Installation
12. FILL UP DIFFERENTIAL OIL Adjustments
13. ADD RESERVOIR WITH BRAKE FLUID
14. BLEED MASTER CYLINDER
15. BLEED BRAKE LINE
16. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
17. INSPECT BRAKE FLUID LEAKAGE
18. INSTALL REAR WHEEL
Torque: 112 Nm (1,142 kgf-cm, 83 ft-lbf)
19. INSPECT AND ADJUST PARKING BRAKE LEVER TRAVEL
HINT: Adjustments

20. INSPECT ABS SPEED SENSOR SIGNAL (w/ ABS)
HINT: Test Mode Procedure