Installation

DRIVE SHAFT: REAR DRIVE SHAFT (for TMMC Made 4WD): INSTALLATION

INSTALLATION

1. INSTALL REAR DRIVE SHAFT ASSEMBLY





(a) Align the shaft splines and install the drive shaft assembly using a brass bar and hammer.
- Set the snap ring with the opening side facing downward.
- Be careful not to damage the oil seal boot and dust cover.
- Move the drive shaft assembly while keeping it level.

2. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY Installation
3. TEMPORARILY TIGHTEN NO. 2 REAR SUSPENSION ARM ASSEMBLY Installation
4. TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY Installation
5. TEMPORARILY TIGHTEN NO. 1 REAR SUSPENSION ARM ASSEMBLY Installation
6. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Air Suspension) Installation
7. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ HID Headlight System) Installation
8. INSTALL REAR AXLE SHAFT NUT Installation
9. INSTALL REAR SPEED SENSOR Installation
10. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76ft-lbf)
11. STABILIZE SUSPENSION Installation
12. FULLY TIGHTEN NO. 2 REAR SUSPENSION ARM ASSEMBLY Installation
13. FULLY TIGHTEN REAR STRUT ROD ASSEMBLY Installation
14. FULLY TIGHTEN NO. 1 REAR SUSPENSION ARM ASSEMBLY Installation
15. ADJUST REAR WHEEL ALIGNMENT
HINT:
Rear Wheel Alignment

16. CHECK HEADLIGHT AIM ONLY (w/ HID Headlight System)
HINT:
Adjustments

17. CHECK ABS SPEED SENSOR SIGNAL
HINT:
Test Mode Procedure