Selector Lever Knob
Selector Lever Knob - 3.5LSelector Lever Knob - 3.5L (Part 1):
Selector Lever Knob - 3.5L (Part 2):
Removal
All vehicles
1. Remove the PRNDL trim ring.
2. Remove the upper console panel.
3. Slide the lower shift knob bezel downward.
4. Remove and discard the 2 bolts from the selector lever knob.
Vehicles equipped with a light bulb
5. Disconnect the light from the PRNDL bezel.
Vehicles equipped with LED illumination
6. Disconnect the LED electrical connector.
All vehicles
7. Disconnect the transmission control (TC) switch electrical connector and remove the wiring harness retainer from the selector lever housing.
8. NOTE: Selector lever removed for clarity.
Release the 3 tabs and remove the PRNDL bezel, selector lever knob and knob bezel.
Installation
All vehicles
1. CAUTION: Be sure that the override lever is inserted in the override lever guide or the shift interlock override button will not work correctly.
NOTE: Selector lever removed for clarity.
Position the TC switch wiring harness through the selector lever knob bezel and the PRNDL bezel and install the PRNDL bezel on the selector lever.
^ Position the override lever in the override lever guide.
^ Make sure that the 3 locking tabs are locked in place.
2. Connect the TC switch electrical connector and install the connector fastener on the selector lever housing.
Vehicles equipped with LED illumination
3. Connect the LED electrical connector.
Vehicles equipped with a light bulb
4. Connect the light to the PRNDL bezel.
All vehicles
5. Position the lower selector lever knob bezel in place.
6. CAUTION: Do not overtighten the selector lever knob bolts or damage to the selector lever or knob may occur.
Install the selector lever knob and 2 new bolts.
^ Tighten to 2 Nm (18 lb-in).
7. Slide the lower selector lever knob bezel up and snap it into place.
8. Install the upper console panel.
9. Install the PRNDL trim ring.
