Seat Backrest - Second Row, 60 Percent

Seat Backrest - Second Row, 60 Percent

Disassembly

60 Percent Backrest

NOTE: Refer to steps in this procedure for inner safety belt guide and safety belt retractor bolt tightening sequence and torque specification.









1. Remove the 60 percent seat from the vehicle. For additional information, refer to Seat - Second Row Seat - Second Row.

2. Remove the 60 percent seat backrest. For additional information, refer to Seat Backrest - Second Row, 60 Percent Seat Backrest - Second Row, 60 Percent.

3. Push the button in on the head restraint guide sleeves and remove the LH and RH head restraints.

4. Squeeze the opening together and remove the outer safety belt trim guide.

5. NOTICE: Use care when separating the seat backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the seat backrest foam.

Release the hook-and-loop strips and invert the backrest cover to the row of hog rings.

6. Remove 5 screws and the backrest hard back panel.

7. Squeeze the tabs in and remove the 4 head restraint guide sleeves.

8. Feed the safety belt through and remove the backrest trim cover and backrest foam pad.

9. Remove the 3 hog rings and the backrest cover.

10. Remove the safety belt retractor and safety belt buckle assembly.
- Remove the 2 inner safety belt guide bolts.

- Remove the safety belt retractor bolt.

Assembly

1. Position the safety belt retractor key through the backrest frame keyway.





2. Position the inner safety belt guide into the backrest frame slot.





3. Hand start the inner safety belt guide bolts and safety belt retractor bolt.

4. Install the 3 bolts in the following sequence.

1. Tighten the RH inner safety belt guide bolt to 23 Nm (17 lb-ft).

2. Tighten the LH inner safety belt guide bolt to 23 Nm (17 lb-ft).

3. Tighten the safety belt retractor bolt to 40 Nm (30 lb-ft).





5. Align the backrest panel to the backrest frame and install 5 screws.

6. Align the backrest cover to the backrest foam pad and install 3 hog rings.

7. Feed the safety belt through the backrest trim cover and backrest foam pad.

8. Align the holes in the backrest cover to those in the backrest frame and foam pad.

9. Roll the backrest trim cover down and attach the hook-and-loop strips.

10. Install the outer safety belt trim guide.

11. NOTE: The LH and RH head restraint guides are not interchangeable.

Install the 4 head restraint guide sleeves.

12. Install the head restraints.

13. Install the 60 percent seat backrest. For additional information, refer to Seat Backrest - Second Row, 60 Percent Seat Backrest - Second Row, 60 Percent.

14. Install the 60 percent seat from the vehicle. For additional information, refer to Seat - Second Row Seat - Second Row.
- Before installation, make sure the safety belts and buckles are accessible to the occupants after installation.

- Verify the safety belt retractor operates without excessive effort or binding.