Seat Track - Front

Seat Track - Front

Removal and Installation

WARNING: Never disassemble or tamper with safety belt buckle/retractor pretensioners or adaptive load limiting retractors or probe the electrical connectors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors which increases the risk of serious personal injury or death.

WARNING: Never probe the electrical connectors on air bag, Safety Canopy(R) or side air curtain modules. Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

NOTE: For component identification and locations, refer to Seat - Exploded View, Front Seat - Exploded View, Front.

1. Remove the front seat backrest. For additional information, refer to Seat Backrest - Front Seat Backrest - Front.

2. Disengage the cushion cover retainers and remove the cushion cover and foam pad from the cushion frame.

3. NOTE: Note all seat wire harness routing for correct installation.

Remove the cushion wire harness.

- For correct passenger seat wire harness routing, refer to Seat Wire Harness Routing Seat Wire Harness Routing.

4. To install, reverse the removal procedure.

5. If equipped with memory seat, operate the seat track in all directions through the full range of travel in the following sequence to set the soft stops.

1. Operate the seat track horizontal motor in one direction until it stops.

2. Press the switch a second time in the same direction to set the soft stop.

3. Repeat the steps for the horizontal motor in the opposite direction.

4. Repeat these steps for the seat track front and rear height motors in both directions.