Turbine Shaft Speed (TSS) Sensor

Turbine Shaft Speed (TSS) Sensor









Removal

1. Remove the main control cover. For additional information, refer to Main Control Cover Service and Repair.

2. Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector.





3. Remove the bolt, route the TSS (Turbine Shaft Speed) sensor wiring harness out of the transaxle case and remove the TSS (Turbine Shaft Speed) sensor.





Installation

1. NOTE: Use a plastic tie strap big enough so that the locking end can not fit through the TSS (Turbine Shaft Speed) sensor electrical connector and long enough so that it can be fed through the transaxle case to pull the TSS (Turbine Shaft Speed) electrical connector through the transaxle case.
Route a plastic tie strap through the electrical connector of the new TSS (Turbine Shaft Speed) sensor electrical connector.






2. NOTE: When routing the TSS (Turbine Shaft Speed) sensor electrical connector through the transaxle case, position the TSS (Turbine Shaft Speed) sensor electrical connector locking tab toward the bottom of the TSS (Turbine Shaft Speed) sensor hole.
Route the plastic tie strap through the TSS (Turbine Shaft Speed) sensor hole and route the tie strap to the main control valve body area. Use the tie strap to pull the TSS (Turbine Shaft Speed) sensor electrical connector through the transaxle case to the main control valve body area. Remove the tie strap from the TSS (Turbine Shaft Speed) sensor.






3. Install the TSS (Turbine Shaft Speed) sensor in the cover and install the bolt.
- Tighten to 12 Nm (106 lb-in).






4. Connect the TSS (Turbine Shaft Speed) sensor electrical connector.





5. Install the main control cover. For additional information, refer to Main Control Cover Service and Repair.