After Repair Procedure

AFTER REPAIR PROCEDURE [AW6A-EL, AW6AX-EL]

CAUTION:
- After repairing a malfunction, perform this procedure to verify that the malfunction has been corrected.
- When this procedure is carried out, be sure to drive the vehicle at lawful speed and pay attention to the other vehicles.

1. Connect the M-MDS to the DLC-2.






2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

- When using the IDS (laptop PC)

- Select "Self Test".
- Select "Modules".
- Select "TCM".

- When using the PDS (Pocket PC)

- Select "Module Tests".
- Select "PCM".
- Select "Self Test".

3. Verify the DTC according to the directions on the M-MDS screen.

4. Press the clear button on the DTC screen to clear the DTC.

5. Perform the following trouble code inspections to ensure that the DTC has been resolved:

P0220-P2764:

P0731-P1783:

P2757-P2758:

6. Gradually slow down and stop the vehicle.

7. Make sure that no DTCs occur.