Oil Pressure Sender: Service and Repair

-
ENGINE OIL PRESSURE (EOP) SWITCH REMOVAL/INSTALLATION - HYBRID

1. With the vehicle in NEUTRAL, position it on a hoist. See Lifting.

2. Remove the pin-type retainer, the 5 bolts and the RH splash shield.

- To install, tighten to 9 Nm {0.9 kgf-m, 80 in-lbf}.

3. Disconnect the Engine Oil Pressure (EOP) switch electrical connector.

4. Remove the EOP switch.

- To install, tighten to 15 Nm {1.5 kgf-m, 133 in-lbf}.

5. To install, reverse the removal procedure.

- Apply thread sealant with PTFE to the EOP switch threads.