Secondary Shaft Gear Component, Primary Shaft Gear Component and Shift Fork and Shift Rod

Secondary Shaft Gear Component, Primary Shaft Gear Component and Shift Fork and Shift Rod

Component Assembly Note





1. Install the shift fork and shift rod component, primary shaft gear component and secondary shaft gear component at the same time.





2. Press the control rod end edge to the back of the scraper and press the push pin component into the inner shift lever.





3. Assemble the shift rod to the clutch housing by tapping the shift rod with a plastic hammer.
4. Pull out the scraper.





5. Rotate the control end so that the push pin component is positioned at the center of the control end.