Camshaft Assembly Note

Camshaft Assembly Note





1. Apply the gear oil (SAE No.90 or equivalent) to each journal of the cylinder head as shown in the figure.
2. Set the cam position of No.1 cylinder at the top dead center (TDC) and install the camshaft.





3. Apply the gear oil (SAE No.90 or equivalent) to each journal of the camshaft as shown in the figure.
4. Temporarily tighten the camshaft cap bolts evenly in 2-3 steps.
5. Tighten the camshaft cap bolts in the order shown with the following two steps.





Tighten torque
1. 5.0-9.0 N-m (51-91 kgf-cm, 45-79 in-lbf)
2. 14-17 N-m (1.5-1.7 kgf-m, 11-12 ft-lbf)