PCM REMOVAL/INSTALLATION [WLT-1, WLT-2]

id014096802400

Note

•  When replacing the PCM, perform the following (WLT-2):

―  Immobilizer system-related part programming (See IMMOBILIZER SYSTEM REPROGRAM PROCEDURE [WLT-2].)

1.  Disconnect the battery negative cable.

2.  Remove the driver’s side front side trim. (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)

3.  Remove in the order indicated in the table.

4.  Install in the reverse order of removal.

abs0zw00002981

1	PCM bracket
2	PCM connector
3	PCM