CYLINDER BLOCK INSPECTION/REPAIR [WL-C, WE-C]

id0110b6501800

1. Measure the distortion of the cylinder block top surface in the seven directions as shown in the figure. Replace if necessary.

dbg110aeb115

Maximum cylinder block distortion

X direction: 0.02 mm {0.0008 in}

Y direction: 0.05 mm {0.002 in}

2. Measure the cylinder bore using the cylinder gauge. Measurement positions are in the X and Y directions at 83 mm {3.27 in} (WL-C) or 88 mm {3.46 in} (WE-C) below the top surface of the cylinder.

• If the cylinder bore exceeds the wear limit, replace the cylinder block or rebore the cylinder and install the oversized pistons so that the specified piston-to-cylinder clearance is obtained.

dbg110beb047

Note

• Base the boring diameter on the diameter of an oversized piston. All cylinders must be the same diameter.

Cylinder bore size [WL-C]

Standard: 93.000—93.022 mm {3.6615—3.6622 in}

0.25 {0.01} oversize: 93.250—93.272 mm {3.6713—3.6721 in}

0.50 {0.02} oversize: 93.500—93.522 mm {3.6811—3.6819 in}

Cylinder bore size [WE-C]

Standard: 96.000—96.022 mm {3.6615—3.6622 in}

0.25 {0.01} oversize: 96.250—96.272 mm {3.7893—3.7902 in}

0.50 {0.02} oversize: 96.500—96.522 mm {3.7992—3.8000 in}

Cylinder bore wear limit

0.15 mm {0.0059 in}