CRANKSHAFT INSPECTION [WL-C, WE-C]

id0110b6502500

1. Measure the crankshaft runout. Replace the crankshaft if necessary.

dbg110aeb089

Maximum crankshaft runout

0.05 mm {0.002 in}

2. Measure the journal diameter in the X and Y directions at the two points (A and B) as shown in the figure. Replace the crankshaft or grind the journal and install the undersize bearing if necessary.

dbg110aeb090

Main journal diameter [No.1,2,4,5]

Standard: 66.937—66.955 mm {2.6354—2.6360 in}

0.25 {0.010} undersize: 66.687—66.705 mm {2.6255—2.6261 in}

0.50 {0.020} undersize: 66.437—66.455 mm {2.6157—2.6163 in}

0.75 {0.030} undersize: 66.187—66.205 mm {2.6058—2.6064 in}

Main journal diameter [No.3]

Standard: 66.920—66.938 mm {2.6347—2.6353 in}

0.25 {0.010} undersize: 66.670—66.688 mm {2.6367—2.6373 in}

0.50 {0.020} undersize: 66.420—66.438 mm {2.6150—2.6156 in}

0.75 {0.030} undersize: 66.170—66.188 mm {2.6052—2.6058 in}

Main journal wear limit

0.05 mm {0.002 in}

Main journal out‐of‐round

0.03 mm {0.001 in}

Crank pin diameter [WL-C]

Standard: 54.940—54.955 mm {2.1630—2.1635 in}

0.25 {0.010} undersize: 54.690—54.705 mm {2.1532—2.1537 in}

0.50 {0.020} undersize: 54.440—54.455 mm {2.1434—2.1438 in}

0.75 {0.030} undersize: 54.190—54.205 mm {2.1335—2.1340 in}

Crank pin diameter [WE-C]

Standard: 56.940—56.955 mm {2.2417—2.2423 in}

0.25 {0.010} undersize: 56.690—56.705 mm {2.2318—2.2324 in}

0.50 {0.020} undersize: 56.440—56.455 mm {2.2220—2.2226 in}

0.75 {0.030} undersize: 56.190—56.205 mm {2.2122—2.2128 in}

Crank pin wear limit

0.05 mm {0.0020 in}

Crank pin out‐of‐round

0.03 mm {0.0012 in}